https://www.avient.com/investor-center/news/polyone-hold-first-quarter-2019-conference-call
Domestic: 1-844-835-7433
International: 1-914-495-8589
Domestic: 1-855-859-2056
https://www.avient.com/investor-center/news/polyone-hold-fourth-quarter-2016-conference-call
Domestic: 1-844-835-7433
International: 1-914-495-8589
Domestic: 1-855-859-2056
https://www.avient.com/investor-center/news/polyone-hold-fourth-quarter-2018-conference-call
Domestic: 1-844-835-7433
International: 1-914-495-8589
Domestic: 1-855-859-2056
https://www.avient.com/investor-center/news/polyone-hold-third-quarter-2016-conference-call
Domestic: 1-844-835-7433
International: 1-914-495-8589
Domestic: 1-855-859-2056
https://www.avient.com/investor-center/news/polyone-hold-second-quarter-2018-conference-call
Domestic: 1-844-835-7433
International: 1-914-495-8589
Domestic: 1-855-859-2056
https://www.avient.com/resource-center/knowledge-base/article/injection-molding-mold-processing?rtype%5B0%5D=1164
Figure 1 shows the typical starting barrel temperatures.
Figure 1.
Zone 1
https://www.avient.com/resource-center/knowledge-base/article/designing-molds-styrenic-block-copolymers-sbc?rtype%5B0%5D=1164
For a bulb-type product that has a maximum diameter to neck diameter of 2-to-1, air ejection is possible with a minimum permanent deflection of the neck.
To make sure the degating process does not pull a hole in the part, the cross sectional size of the gate should be between 1/10 and 1/4 the thickness of the part wall section where the gate is located.
https://www.avient.com/news/polyone-acquires-specialty-assets-accella-performance-materials
December 1, 2014
DeLuca
Vice President, Investor Relations
PolyOne Corporation
+1 440-930-1226
isaac.deluca@avient.com
Rose
Director, Corporate Communications
PolyOne Corporation
+1 440-930-3162
kyle.rose@avient.com
https://www.avient.com/products/long-fiber-technology/complet-maximum-toughness
1-2%
1-2%
1%
https://www.avient.com/resource-center/knowledge-base/article/designing-molds-styrenic-block-copolymers-sbc
For a bulb-type product that has a maximum diameter to neck diameter of 2-to-1, air ejection is possible with a minimum permanent deflection of the neck.
To make sure the degating process does not pull a hole in the part, the cross sectional size of the gate should be between 1/10 and 1/4 the thickness of the part wall section where the gate is located.