Ejector Pin Design Guidelines When designing ejector pins, the following guidelines should be used, which can be seen in figure 42. If the material is shear-sensitive, consult the material data sheet or processing guide for instructions to set recovery time • The cooling time should only be 1–2 seconds longer than the screw recovery time, unless dictated by dimensional stability or part thickness Minimize Clamp Pressure This step is done to reduce the amount of energy used by the machine. • Reduce the clamp tonnage until flash is seen around the parting line, then increase the clamp tonnage by 5-10% Minimize Cycle Time • Mold Open/Close – Should be as fast as possible, without slamming, and still produce a nice fluid motion • Ejector Speed – As fast as possible, without influencing part quality • Ejector Stroke – Only stroke the ejectors as many times as needed to separate the part from the core - i.e. Note: Once the process has been established, the parts should be tested for dimensional stability over the range of service termperatures.

PE VIOLET SHEET UV 254C Technical Data Sheets Safety Data Sheets

YLWPWDMB (50% 42-170A) 650A Technical Data Sheets Safety Data Sheets

9261-42 SLATE BLUE FURNITURE PLASTISOL Technical Data Sheets Safety Data Sheets

42 RED Technical Data Sheets Safety Data Sheets

STAN-TONE HCC- RED 42-2 V-F Technical Data Sheets Safety Data Sheets

X040-033-42-02 VIPER PROFILES Technical Data Sheets Safety Data Sheets

YLWPWDMB (5% 42-170A) 450A Technical Data Sheets Safety Data Sheets

RMB YLWPWDMB (5% 42-170A) Technical Data Sheets Safety Data Sheets

50% 42-170 Yellow Technical Data Sheets Safety Data Sheets