2.

2.

2.

These new Level 1, 2, and DC chargers must meet critical standards and strict performance specifications.

These new Level 1, 2, and DC chargers must meet critical standards and strict performance specifications.

TEST METHOD Fifteen bars of each material were placed into jigs at 1% and 2% strain. This procedure was completed by placing one 1/2 inch section of rayon gauze at the apex of each bar, and soaking the gauze with the disinfectant to saturate the material.

Trilliant™ HC high performance formulations were developed for specific healthcare enclosure needs, including: • Chemical resistance to common disinfectants • UL 94 ratings of 5VA at 3.0, V-0 at 1.5 mm & V-1 at 0.75 mm • Retained color aesthetics after chemical exposure • Ability to utilize existing PC/PET & COPE tooling Tested using an adaptation from ASTM D543 for environmental stress cracking resistance (ESCR), 15 bars of each material were placed into jigs at 1% and 2% strain. This procedure was completed by placing one 1/2 inch section of rayon gauze at the apex of each bar, and soaking the gauze with the disinfectant to saturate the material.

TECHNICAL PROPERTIES(1) TEST METHOD Complēt LGF30-PKE NAT Complēt LGF40-PKE NAT Complēt LGF50-PKE NAT Physical Density/Specific Gravity ASTM D792 1.47 1.54 1.66 Mechanical Tensile Strength (Yield) ASTM D638 21,100 psi 24,700 psi 26,400 psi Tensile Modulus(2) ASTM D638 1,150,000 psi 1,570,000 psi 2,150,000 psi Flexural Modulus(3) ASTM D790 1,120,000 psi 1,480,000 psi 2,030,000 psi Flammability (non-PFAS options available) Flame Rating @ 1.5 mm UL 94 V-0 V-0 — COLD IMPACT PERFORMANCE Ft -lb /in Data based on single lot of lab-generated samples. Values are not to be construed as specifications. (2) 0.20 in/min (3) 0.05 in/min

The issuance of orders by Buyer implies full acceptance of these Terms and Conditions which shall prevail over Buyer's terms and conditions in the event they contradict or deviate from these Terms and Conditions. 2. L'émission de bons de commande par l'Acheteur implique l'acceptation pleine et entière des Conditions Générales de Vente qui prévaudront sur les conditions générales de l'Acheteur en cas de contradiction ou de divergence avec les présentes Conditions Générales de Vente. 2. Seller may deliver to Buyer a quantity of Products with a quantity tolerance which may vary, depending upon the quantities ordered by Buyer, as follows: (1) from 50 to 99 kgs, +/- 25%; (2) from 100 to 249 kgs, +/- 15%; (3) from 250 to 499 kgs, +/- 10%; (4) more than 500 kgs, +/- 5%.

Examples of typical DMA results are shown in Figure 2. The mechanical properties change was found less than 5 percent and dimensional change is less than 2 percent. TEM of high molecular weight SEBS/Oil/PP compound ANTEC 2003 / 3037 Figure 2.