https://www.avient.com/products/engineered-polymer-formulations/general-engineered-formulations/lubrione-internally-lubricated-formulations
Get Help Now
+1-866-737-2066
https://www.avient.com/knowledge-base/article/could-polyketone-be-next-generation-nylon-alternative
Aliphatic polyketone, often referred to as just polyketone or PK, is a semi-crystalline engineering resin that is an alternating copolymer of carbon monoxide and ethylene with some propylene (1–10%).
https://www.avient.com/knowledge-base/article/could-polyketone-be-next-generation-nylon-alternative?utm_source=PANTHEON_STRIPPED&utm_medium=PANTHEON_STRIPPED&utm_campaign=PANTHEON_STRIPPED
Aliphatic polyketone, often referred to as just polyketone or PK, is a semi-crystalline engineering resin that is an alternating copolymer of carbon monoxide and ethylene with some propylene (1–10%).
https://www.avient.com/company/sustainability/sustainability-report/planet/energy-ghg-emissions
To drive progress toward carbon neutrality, Avient’s low carbon transition plan targets intermediate (2030) goals around Scope 1 (direct) and Scope 2 (indirect) sources of greenhouse gas emissions.
Most of Avient’s Scope 1 and 2 GHG emissions are attributable to the consumption of energy.
Scope 3 emissions are many times greater than our combined Scope 1 and 2 emissions.
https://www.avient.com/resources/safety-data-sheets?page=5116
GMF 604 40 UV BLACK 115 1 X1
VERSAFLEX(TM) 9555-1 NATURAL BASE
Shipment Notification - under "Material Header" MSDS - labeled as the "Product Number" (in Section 1)
https://www.avient.com/knowledge-base/article/designing-molds-styrenic-block-copolymers-sbc
For a bulb-type product that has a maximum diameter to neck diameter of 2-to-1, air ejection is possible with a minimum permanent deflection of the neck.
To make sure the degating process does not pull a hole in the part, the cross sectional size of the gate should be between 1/10 and 1/4 the thickness of the part wall section where the gate is located.
https://www.avient.com/knowledge-base/article/designing-molds-styrenic-block-copolymers-sbc?rtype[]=1164
For a bulb-type product that has a maximum diameter to neck diameter of 2-to-1, air ejection is possible with a minimum permanent deflection of the neck.
To make sure the degating process does not pull a hole in the part, the cross sectional size of the gate should be between 1/10 and 1/4 the thickness of the part wall section where the gate is located.
https://www.avient.com/news/polyone-acquires-specialty-assets-accella-performance-materials
December 1, 2014
DeLuca
Vice President, Investor Relations
PolyOne Corporation
+1 440-930-1226
isaac.deluca@avient.com
Rose
Director, Corporate Communications
PolyOne Corporation
+1 440-930-3162
kyle.rose@avient.com
https://www.avient.com/products/long-fiber-technology/complet-maximum-toughness
1-2%
1-2%
1%
https://www.avient.com/investor-center/news/avient-announces-tenth-consecutive-annual-increase-quarterly-dividend
Investor Relations Contact: Joe Di Salvo, Vice President, Treasurer and Investor Relations, Avient Corporation, +1 440-930-1921, giuseppe.disalvo@avient.com; Media Contact: Kyle G.
Rose, Vice President, Corporate Communications, Avient Corporation, +1 440-930-3162, kyle.rose@avient.com